Moving from Culver City to Silver Lake

Moving from Culver City to Silver Lake is a local move — typically 3–6 hours depending on home size and parking.

What to Know About This Move

At Culver City

Culver city tech offices, mixed-use buildings and quiet residential blocks. Washington Blvd has good loading access; side streets are open.

At Silver Lake

Silver lake hillside homes, bungalows and dense apartment corridors. Hillside streets near the Reservoir are narrow — smaller trucks recommended.

Culver City to Silver Lake: distance, timing and drive-time cost

Roughly 11 miles by road, running north-east across the county. Off-peak a loaded truck covers it in about 20 minutes; inside the 7–10 AM and 3–7 PM windows the same drive runs past 40 minutes. California bills travel between your two addresses at double time, so at $88/hr an off-peak Culver City–Silver Lake leg comes to about $60.

Pricing for This Route

Home Size	Est. Hours	Est. Total
Studio	2.5–3.5 hrs	$248–$347
1-Bedroom	3–5 hrs	$297–$495
2-Bedroom	5–7 hrs	$495–$693
3-Bedroom	7–9 hrs	$693–$891

Rate: $88/hr · 2 movers + truck · 2-hour minimum. Drive time between Culver City and Silver Lake (I-10 and 405 access makes Culver City central for cross-city moves) is included in the clock.

What's Always Included

✓2 professional W-2 movers + full-size truck
✓Moving blankets, shrink wrap, furniture pads
✓Furniture disassembly and reassembly
✓Stair and elevator handling — no surcharges
✓COI issued within 24h for buildings that require it
✓Parking coordination at both ends

Culver City to Silver Lake — FAQ

How much does it cost to move from Culver City to Silver Lake?

Most Culver City to Silver Lake moves cost $300–$650 total (3–6 hours at $88/hr for 2 movers + truck). The exact time depends on home size, stairs, and parking at both ends.

How long does a move from Culver City to Silver Lake take?

Typically 3–5 hours for a 1-bedroom, 5–7 hours for a 2-bedroom. Washington Blvd has good loading access; side streets are open.

Do you handle parking for the Culver City to Silver Lake move?

Yes — we plan parking at both ends before move day. Hillside streets near the Reservoir are narrow — smaller trucks recommended. We pull temporary no-parking permits when needed.

Culver City to Silver Lake: what this move involves

Leaving Culver City often means a downtown apartment near the Expo Line, where a freight elevator and COI are part of the move. Arriving in Silver Lake brings steep, narrow streets and stair access that we plan with staging and the right truck. We schedule the freeway leg outside rush windows, since the drive between them is billed double under California rules.